Following the process described previously I came up with an 11 to 12 degree angle from the hoirzontal plane. This checks with virtually every other reference. Once we angle the cone up 1/2 of this value and establish a center line we'll start on the neck and go over some details. Updates will be few the next couple of days, but I will try to get back to this ASAP. If you want to learn more about taper etc xheck out the link below.
http://www.practicalmachinist.com/vb/showthread.php/converting-ft-taper-into-156106.html?s=e2ffdc4b49bb68459ffc8168ef024c72&
As always, Keep on Trekkin! =/\=
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.